Network Shutdown Module V3
User guide
Network Shutdown Module V3 – User Manual Page 30/53
6.3 Create a multi-UPS configuration
For the multi-UPS configurations, you have to enter the IP address of each UPS that electrically powers the
machine hosting the Network Shutdown Module.
From the, Configuration->Communication page, please proceed as follows:
Multi-UPS configuration
• Click on the Add button
• Key in the first IP address
• Key in the next IP addresses (Click on the Add button).
• Select the Redundancy type of your installation (Parallel, STS, Sequential, Serial, Server with multiple
power supplies) according to your electrical configuration.
Note: For the Hot Standby/Sequential UPS Model refer to the specific UPS configuration
• (optional) key in the Minimal number of redundant UPSs powering your system:
The default value is 0.
If you set this parameter to a higher level you will receive the Redundancy Lost alarm when you don’t
have enough redundant UPSs.
Note: We warn you against the consequences of these settings, but you also have the possibility to
trigger the shutdown action on “Redundancy Lost“ alarm in the actions settings.
• Click on the Save button
Comments to this Manuals