APC mart-UPS RT 10,000VA RM 208V w/ (2) 208V to 120V 2U Step-Down Transformer User Manual download pdf (Page 7)

ONNECTING POWER AND EQUIPMENT TO THE UPS

1. Hardwire the UPS (see Hardwiring).

2. Connect equipment to the UPS (cables not included for XLT/XLJ/XLTW models).

3. Turn on all connected equipment. To use the UPS as a master on/off switch, be sure that all

connected equipment is switched ON.

4. Press the

button on the front panel to power up the UPS.

• The battery charges to 90% capacity during the first three hours of normal operation. Do not

expect full battery run capability during this initial charge period.

5. Configure the Web/SNMP management card (optional).

PTIONS

Refer to the APC web site, www.apc.com

for available accessories.

 External Battery Pack SURT192XLBP

 Rail Kit SURTRK2

 Isolation Transformer

 Service Bypass Panel

IRCUIT BREAKERS

Input Circuit Breaker

7500/10000 VA

XLI/XLJ/XLT/XLTW

The UPS is protected from extreme overloads when in ON position.

The breaker must be on for the UPS to operate.

Output Circuit Breaker

7500/10000 VA

XLJ/XLT/XLTW

Output Circuit Breaker

7500/10000 VA XLI

L6-30

250V 30A

L6-20

250V 20A

IEC 320-C19

16A for each

receptacle

IEC 320-C13

10A for each

receptacle

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

No comments

APC mart-UPS RT 10,000VA RM 208V w/ (2) 208V to 120V 2U Step-Down Transformer User Manual Page 7