APC SURTD3000RMXLI Specifications download pdf (Page 8)

ONNECTING EQUIPMENT AND POWER TO THE UPS

1. Connect equipment to the UPS (cables not included for XLJ/XLT/XLTW models).

2. Avoid using extension cords.

• 3000 VA XLJ/XLT/XLI/XLTW and 5000 VA XLJ/XLT/XLTW models: Using a power cord,

plug the UPS into a two-pole, three-wire, grounded receptacle only.

• 5000 VA XLJ models: To draw full 5000 VA from the UPS have a qualified electrician cut

off the input plug and hardwire the UPS to the appropriate power panel.

3. Turn on all connected equipment. To use the UPS as a master ON/OFF switch, ensure all

connected equipment is switched ON. The equipment will not be powered until the UPS is

turned on.

4. To power up the UPS press the

button on the front panel.

• The UPS battery charges when it is connected to utility power. The battery charges to 90%

capacity during the first three hours of normal operation. Do not expect full battery run

capability during this initial charge period.

5. For additional computer system security, install PowerChute

Server Smart-UPS monitoring

software.

PTIONS

Refer to the APC Web site, www.apc.com

for available accessories.

 External Battery Pack SURT192XLBP

 Rail Kit SURTRK2

 Isolation Transformer

 Service Bypass Panel

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

No comments

APC SURTD3000RMXLI Specifications Page 8