APC RAID Subsystem SCSI-SATA II User Manual download pdf (Page 50)

SCSI to SATA II RAID Subsystem

User Manual

5.3 Configuration using the proRAID Manager GUI

The RAID subsystem can be managed through the controller’s Ethernet connection.

Any PC on the network to which the RAID subsystem is connected can manage the

subsystem using proRAID Manager. proRAID Manager is web browser-based

Graphical User Interface (GUI) that is supported on many OS platforms.

This chapter describes the steps that you need to start up ProRAID Manager and

how to use it on your system.

NOTE: Flash Player 10 or later version must be installed in the PC

which will be used to manage the RAID subsystem.

5.3.1 Login to proRAID Manager

Open a web browser and enter http://xxx.xxx.xxx.xxx, where xxx.xxx.xxx.xxx is the IP

address of the RAID subsystem. The Login screen will be displayed.

Enter the subsystem name (you can use any name to identify the subsystem you are

going to manage) and the password.

NOTE: The default IP address of the RAID system is 172.16.0.1.

The IP address can be verified from LCD panel; select System

Config and then Ethernet Config. The default subsystem password

is 00000000.

NOTE: The session timeout limit is 10 minutes. When the GUI is

not used within 10 minutes, user will be logged out automatically.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 89 90

No comments

APC RAID Subsystem SCSI-SATA II User Manual Page 50