APC RAID Subsystem SCSI-SATA II User Manual download pdf (Page 56)

SCSI to SATA II RAID Subsystem

User Manual

2. Enter Array Name, Volume Name, select the disk drives to be included in

the Array, and select RAID Level, Stripe Size, and Block Size. Click

“Submit” when done.

Option Description

Array Name

The name of the array you want to assign to the

Array. It should not exceed 20 characters.

Volume Name

The name of the volume you wan to assign to the

Volume. After mapping the Volume as LUN, it will

appear as a disk device to the host.

RAID Level

Select the RAID Level you want the Array to use.

The RAID level option will depend on the number of

disk drives selected.

Stripe Size

This parameter sets the size of the stripe written to

each disk. You can set the stripe size to 8k, 16k,

32k, 64k, 128k, 256k or 512k.

Block Size

Use this option to enable creating Volume over

2TB.

For Windows OS, such as Windows 2000, 2003:

Use 1KB, 2KB or 4KB.

For 64bit LBA mode, such as Windows 2003+SP1

or later versions, Linux 2.6 or later versions:

Use 512 bytes. Due to LSI chip limitation,

16 Byte CDB option must run at U320 mode.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 89 90

No comments

APC RAID Subsystem SCSI-SATA II User Manual Page 56