Apc ADSL 4-Port User Manual download pdf (Page 40)

ADSL 4-Port Ethernet USB Wireless-G Router User Guide

ADSL 4-Port Ethernet USB Wireless-G Router User Guide Page 40 of 52

Figure 1-36 : Access Control

5.6.19

Static Routing

If the ADSL Router is connected to more than one network, you may need to set up a static route

between them. A static route is a pre-defined pathway that network information must travel to

reach a specific host or network. You can use static routing to allow different IP domain users to

access the Internet through the ADSL Router.

The New Destination IP is the address of the remote LAN network or host to which you want to

assign a static route. Enter the IP address of the host for which you wish to create a static route

here. For a standard Class C IP domain, the network address is the first three fields of the New

Destination IP, while the last field should be 0. The Subnet Mask identifies which portion of an

IP address is the network portion, and which portion is the host portion. For a full Class C

Subnet, the Subnet Mask is 255.255.255.0. The Gateway IP address should be the IP address of

the gateway device that allows for contact between the Gateway and the remote network or host.

The Hop Count determines the maximum number of steps between network nodes that data

packets will travel. A node is any device on the network (such as a router or switch)

See Fig 1-37

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 51 52

No comments

Apc ADSL 4-Port User Manual Page 40