APC AXFA11G User Manual download pdf (Page 29)

IM 01E20C01-01E

6-1

6. PARAMETER DESCRIPTION

6.1 Parameters

With the exception of parameters that were specified

by the customer upon ordering, all of the AXFA11’s

internal parameters will initially be set to default

values. Actions such as the modification of display

details can then be carried out whenever necessary.

IMPORTANT

Make sure to keep the AXFA11’s power on at

least for 30 seconds after you set the param-

eters. If you turn the power off immediately after

the parameters are set, the settings will be

canceled.

NOTE

In order to ensure that correct flow rate data can

be acquired, it is crucial that the nominal size,

flow rate span, and meter factor of the combined

remote flowtube are setup. In cases where a

remote flowtube is ordered at the same time as

the AXFA11, the nominal size and meter factor

will be setup upon shipment from the manufac-

turing plant, and these will not require additional

setting. If the AXFA11 is ordered individually, the

default value will be setup for the meter factor;

accordingly, it will be necessary to change this

setting to the meter factor indicated on your

remote flowtube data plate.

If a flow rate span is specified upon ordering,

this will be set before shipment. If this is not the

case, however, it will be necessary for the

appropriate value to be set up by the user.

6.2 Parameter Lists

Parameter lists are comprised of the following items.

Item Name

Data

range

Default

value

Units

Position of

decimal point

R/W

Description

T0601.EPS

Describes the parameter content.

The units corresponding to the data range.

R: Read only

W: Writable

Parameter number.

The default value (as setup upon plant shipment).

If marked “(*)”, it indicates that the appropriate

setting has been made in accordance with

ordering information and data for a remote

flowtube to be combined.

This item defines the range of data to be set for

numeric parameters and also defines selection of

data for selection-type parameters.

The position of the decimal point within the data

range and also the allowed relocation range in

terms of places of decimals.

The name of the parameter. Entries in parentheses

indicate the parameter name displayed on the

handheld BRAIN Terminal (BT200).

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 117 118

Comments to this Manuals

No comments

APC AXFA11G User Manual Page 29

Comments to this Manuals