APC Network Management Card Installation Manual download pdf (Page 7)

Installation Manual

Installation in a Symmetra PX UPS

You do not need to turn off the power for a Symmetra PX 250 or Symmetra PX

500 UPS before you remove or install the Management Card.

The Network Management Card is sensitive to static electricity.

When handling the Management Card, touch only the end plate

while using one or more of these electrostatic-discharge devices

(ESDs): wrist straps, heel straps, toe straps, or conductive shoes.

For the location of the UPS card slot, see the UPS documentation.

1. Locate the UPS card slot.

2. Use the same screws that hold the slot cover in place to secure the

Management Card in the UPS card slot.

3. Connect a network interface cable to the 10/100Base-T network

connector



on the Management Card.

dmp0096a

Smar t Sl ot

ModemUniversal I/O

Config

Reset

10/100

Network

9635 Network Manage ment Card 2

USB

Modbus

Gnd

TXD

RXD

Com

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

No comments

APC Network Management Card Installation Manual Page 7