APC AP9211 Datasheet download pdf (Page 10)

Quick Configuration

continued

Configuring

TCP/IP settings,

continued

Serially through the Control Console. If you are not using a

Windows platform, or you require direct serial configuration,

use the Serial Console port to configure the

TCP/IP

settings for

the Management Card, as follows:

1. Connect the supplied null-modem cable (

APC

part

number

940-0103

) to an available serial port on your

computer and to the serial port on the front panel of the

MasterSwitch unit.

2. Disable PowerChute Plus,

UNIX

Respond, or other

service that may be using the serial port on the

computer.

3. Run a terminal emulator such as Windows

HyperTerminal. Configure the appropriate serial port

with the following settings:

2400

bps, no parity,

data

bits,

stop bit, and no flow control.

Note: Some terminal emulators, such as

HyperTerminal, require that you disconnect and

reconnect in order for the new serial settings to

take effect.

4. From your computer, press

NTER

until the user name

prompt appears.

5. Enter the default user name and password:

apc

lowercase.

6. On the Main menu, choose Network.

7. From the Network menu, choose TCP/IP.

8. Within the TCP/IP menu do the following:

a. Disable

BOOTP

, and accept changes.

b. Set a valid

address, Subnet Mask and default

gateway for your network, and accept changes.

c. Press

until the Main menu appears, then select

Logout.

Note: The new settings take effect when you log out.

Continued on next page

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

APC AP9211 Datasheet Page 10

Comments to this Manuals

Related products and manuals for Power distribution units (PDUs) APC AP9211