APC AP9211 Datasheet download pdf (Page 9)

Quick Configuration

Required

configuration

You must configure the following network settings for the

MasterSwitch

PDU

before it can operate on a network:

•

address of the MasterSwitch

PDU

• Subnet Mask

•

address of the default gateway

After you configure MasterSwitch network settings, no further

configuration is required. The remaining MasterSwitch

properties are pre-configured at the factory. However, you may

want to customize these properties for your application. See

“Managing the MasterSwitch

PDU

” in the User’s Guide on the

enclosed CD for more information.

Configuring

TCP/IP settings

Choose the configuration method appropriate for your

environment:

• If you are using Windows

, Windows

, or Windows

, see “Through the Management Card Wizard” on

page 5.

• If you are not using a Windows-based operating system

or if you require direct serial configuration, see “Serially

through the Control Console” on page 6.

• If you are a network administrator using Address

Resolution Protocol (

ARP

), see “Over the Network by

ARP” on page 7

• If you are a network administrator using

BOOTP

, see

“Over the Network by BOOTP” on page 7.

Through the Management Card Wizard. On Windows

95,

Windows

, or version

4.0

of Windows

NT,

use the

Management Card Wizard to configure all attributes quickly,

including

TCP/IP

settings, for the pre-installed Management

Card. Use the

CD-ROM

supplied with the MasterSwitch

PDU

and follow the on-screen instructions.

The pre-installed Management card provides the network

interface for the MasterSwitch

PDU

Continued on next page

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

APC AP9211 Datasheet Page 9

Comments to this Manuals

Related products and manuals for Power distribution units (PDUs) APC AP9211