APC AP9423U Datasheet download pdf (Page 15)

InfraStruXure Manager 11

Initial Configuration

Configure the InfraStruXure Manager

To configure the InfraStruXure Manager for the first time you must connect to the manager and run

the APC InfraStruXure Manager Setup Wizard on the client interface. You have two options for

connecting to the manager:

• Connect from the private network (APC LAN) with a computer connected to the APC switch

(or hub). This method is recommended if you do not know the IP address assigned to the

InfraStruXure Manager on the public network (User LAN), or your network does not use a

DHCP server to assign IP addresses.

• Connect from the public network (User LAN). You can use this method if you know the IP

address assigned to the InfraStruXure Manager on the public network (User LAN).

Configure the InfraStruXure Manager from the Private Network (APC LAN)

1. Connect a computer to a network port on the APC switch (or hub). The computer must meet the

following requirements:

– It must be configured to automatically obtain an IP address (through DHCP).

– It must be running TCP/IP as a network protocol.

– The browser must be Microsoft

Internet Explorer, version 5.5 or higher.

2. Release and renew your computer’s IP address to assign it an address on the APC LAN.

3. Open Microsoft Internet Explorer browser, version 5.5 or higher, and enter the APC LAN IP

address for the InfraStruXure Manager:

– Use 192.168.1.1 as the default IP address for the InfraStruXure Manager on the APC LAN.

– Use 10.0.1.1 if, for any reason, you cannot use the default IP address above.

4. If the Security Warning appears, click Yes to download the APC InfraStruXure Manager

Client.

5. When the Server Log On display appears, use apc (lowercase) for both the username and

password, and click Connect.

6. In the Confirm display, click Yes to run the APC InfraStruXure Manager Setup Wizard.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

No comments

APC AP9423U Datasheet Page 15