APC EP Zero ARF Instruction Manual download pdf (Page 19)

❏

3. Mix up some 6-minute epoxy and thin it down with

some denatured alcohol. Brush it onto the ESC tray and the

battery tray to prepare the wood. Allow the epoxy to cure.

❏

4. Cut 5" of non-adhesive backed hook and loop material.

Separate the hook side from the loop side and join the two

pieces so that 1-1/2" [38mm] overlaps in the middle.

❏

5. Cut a 1-1/4" [32mm] and a 3/4" [19.1mm] piece of adhesive

backed hook and loop material. Stick the hook side to the battery

tray as shown. Fit the strap you made to the battery tray

❏

6. Cut a 1-1/2" [38mm] piece of adhesive backed hook

and loop material. Stick one side to the back of the ESC and

the other side to the ESC tray. Clean the back side of your

ESC with some denatured alcohol before you stick the hook

and loop material onto it.

❏

7. Glue the ESC tray into the fuselage as shown. Fit the

ESC. Connect the ESC leads to the motor leads.

❏

8. Use the remaining adhesive backed hook and loop

material to attach your receiver to the radio equipment tray.

Connect the elevator and rudder servo leads to the receiver.

Plug a Y-connector into the aileron channel and a Y-connector

into the flap channel (if you are using flaps). Connect the

ESC servo plug to the throttle channel on your receiver.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

No comments

APC EP Zero ARF Instruction Manual Page 19