Apc SmartSlot Series User Manual download pdf (Page 7)

3. Operation Check

1. Confirm the basic operation of Measure-UPS II. Use the data

reporting system (see hardware and software compatibility in sec-

tion 1) to confirm that Measure-UPS II is working. With the probe

(temperature or temperature and humidity) connected to probe

connector 1, Measure-UPS II should transmit temperature or tem-

perature and humidity values to the reporting system. Note:

Reported humidity values will be less than 2% RH when using the

temperature only probe. If the probe is not properly connected

both temperature and humidity readings will be very low.

2. Confirm contact sensing by activating each sensor in turn accord-

ing to the sensor manufacturers recommendation. Use the data

reporting system to verify that each sensor operates as planned.

1 2 3 4 5 6 7 8 9 10 11 12 ... 16 17

No comments

Apc SmartSlot Series User Manual Page 7