56
OPERATING PROCEDURES: AR (refractive error) and KM (corneal curvature radius) Measurements
5 Press the right button or left button to
align the guide line on the right of the patient’s
pupil.
The guide line to be aligned is displayed in pink
6 Press the down button to change the
selected guide line.
The left guide line is displayed in pink.
Each time the switch is pressed, the guide line is
displayed in pink right and left, alternately.
7 Press the right button or left button to
align the guide line with the left end of the
patient’s pupil
8 Press the start button to confirm the measure-
ment.
A PS value (0.1 mm increments) is displayed in
the lower part of the screen.
9 Press the start button again, measure the other eye in the same manner.
10
Press the exit button to exit from PS measure-
ment.
he screen returns to the measurement screen.
The PS-measured data is displayed on the
screen, indicating the completion of PS mea-
surement.
• When the right button or left button has never been pressed, the measured
values are not displayed. Start measurement again from capturing.
• When the AI MODE parameter is set to YES and the PRINT parameter is set to AUTO, PS
measurement must be performed before AR and/or KM measurement to be able to print
the data together with AR- and/or KM-measured data.
ᴹᵍᵒᵍᵆᵉǽᵐᵆᵗᵂᴻ
ᵉᴾᵊᵍᴷᵌᵋ
Align the guide line on the right of the pa-
tient's pupil.
ᴹᵍᵒᵍᵆᵉǽᵐᵆᵗᵂᴻ
ᵉᴾᵊᵍᴷᵌᵋ
ᴳᴫᴲᵪᵪ
Align the guide line with the left end of the
patient's pupil.
㧼㧿ޓ㧢㧚㧡
㧯㧿㧝㧞㧚㧜
ᵏᴷᴰǽǽǽǽǽᵈᴷᴰǽ
ᵐᴪǽᴮ
ᴫ
ᴯᴲǽᵏᴮǽǽᴴᴫᴶᴵǽᴮᴴᴰ
ᵀᴪǽᴭ
ᴫ
ᴴᴲǽᵏᴯǽǽᴴᴫᴲᴶǽǽᴵᴰ
ᴾǽǽǽǽǽᴯǽǽǽǽǽǽǽǽǽᵍᵁᴳᴱ
ᵏ
ᴥᴶᴦ
The PS value is displayed.
Comments to this Manuals