APC ACF002 Datasheet download pdf (Page 9)

NetworkAir RM Air Distribution Unit 5

Overview

Tools required You will need the following to install the Air Distribution Unit:

• Pencil

• Saw or other tool for cutting a hole in the raised floor

tile(s) (raised floor application only)

• Caged nut tool (provided)

• 7-mm spanner or nut driver

• Phillips screwdriver

Overview of the

installation

procedure

The Air Distribution Unit can be installed in both raised-floor

and non–raised-floor applications. The unit is installed in the

bottom 2U of the NetShelter enclosure or other 19" EIA 310-D

enclosure with an open or removable floor. The raised floor

application will require an opening in the raised floor, directly

under the enclosure. With the enclosure in place, install several

parts of the Air Distribution Unit so that you can mark the

location and size for this opening. Then move the enclosure

and remove the floor tile(s) to cut the opening. After

reinstalling the tiles and the enclosure, complete the

installation. See the following paragraphs in this section for the

installation procedure.

Equipment

placement

To avoid interference with air flow, use the uppermost part of

the enclosure for any equipment that extends forward over the

air outlet of the Air Distribution Unit.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

No comments

APC ACF002 Datasheet Page 9