Note: This threshold setting is useful for sensors
that can report more than two states.
Other state thresholds
The Other State Sensors option allows you to set thresholds for state sensors that monitor
operational states not covered by the three threshold-specific, state options.
The following lists identify some common examples of state sensors you can configure
using the Other State Sensors option. The actual sensors will depend on the device types
managed by the StruxureWare Central server.
These options use the same set of four threshold settings as the other state threshold
options.
Note: You can configure multiple sensors discovered for the Other State Sensors option,
when the sensors you select use the same alarm states settings. For example, all sensors
that use On and Off states can be configured at the same time, as can all sensors that
use Up and Down.
Active/Inactive:
• Button
• Temperature
Override Status
Open/Closed:
• Input Contact
• Output Relay
• Bypass
On/Off:
• Switch
• Outlet
• Alarm Device
• Test Relay
Other Settings:
• Ethernet Link
• UPS Input Voltage
(line neutral)
• Current Output
Phase
Fault/No Fault:
• Contact
• Input State
Connected/
Disconnected:
• Speakers
• External Microphone
Yes/No:
• UPS on Bypass
• UPS on Battery
• Audio Alarm
• Battery Low
• Overload
• Inverter Off
• UPS Over
Temperature
• Utility Power Failure
• Battery Needs
Replacement
• Battery Fault
Multiple Statuses::
• Online
• Device Status
• Battery Status
• UPS Status
• Communication
Status
• Alarm State
• Self-Test
• Runtime Calibration
• Reason for Last
Transfer to Battery
• Battery Charge Fault
• Rack ARU Operating
Status of Fan
• ARU Primary Power
Present
"Select Threshold Type" display
This display allows you to select the type of threshold for which you want to create an alarm.
You use this display to choose the type of threshold you want to create on any available
sensors for the device group or device you select. The types of thresholds available depend
on the type of sensor you select.
Note: Once you access this display, you must select a threshold type and click Next or
click Cancel to exit the wizard.
StruxureWare Central 6.3.0
140
Comments to this Manuals