APC UTS6H Specifications download pdf (Page 38)

iv. System controller

1. Micro-processor based with heating algorithm

2. Internet connector (RJ 45 compatible)

3. Outdoor temperature sensor (10 ohm) with outdoor mounting box

v. Thermostat

1. 24 Volt AC

2. Programmable, communicating-type w/ LCD screen

3. Non-volatile program and setting memory: no batteries required for long-term operation

4. Energy Star compliant

2.02 ACCESSORIES

B. Condensate Removal: Supply approved means to remove condensate for the furnace and MCHP.

PART 3 – EXECUTION

3.01 MANUFACTURER’S INSTRUCTIONS

C. Compliance: Comply with manufacturer’s product data, including product technical bulletins, product catalog

installation drawings and instructions.

D. Coordination: Coordinate any electrical or mechanical requirements for these connections.

3.02 EXAMINATION

E. Site Veriﬁ cation or Conditions: Verify that ﬂ oor conditions are acceptable for product installation in accordance

with manufacturer’s instructions.

F. Footprint: Verify that ﬂ oor space is acceptable for product installation in accordance with manufacturer’s

instructions.

G. Intake/Vent Pipe Routing: Verify that air intake and vent pipe chases and termination locations are acceptable for

product installation in accordance with manufacturer’s instructions.

H. Condensate Removal: Verify that condensate removal locations are acceptable for product installation in

accordance with manufacturer’s instructions.

3.04 INSTALLATION

D. Certiﬁ cation: Verify that installers have valid certiﬁ cation from the manufacturer to install and service the Warm

Air Micro-CHP System.

E. Warm Air Micro-CHP System: Install in accordance with manufacturer’s installation instructions.

F. Accessories: Install in accordance with manufacturer’s installation instructions.

END OF SECTION

GUIDE SPECIFICATION

1 2 ... 33 34 35 36 37 38 39 40

No comments

APC UTS6H Specifications Page 38