APC Network Management Card AP9618 User's Guide download pdf (Page 6)

2 Installation and Quick Start

How to Recover from a Lost Password

You can use a local computer that connects to the Management

Card or other device through the serial port to access the

control console.

1. Select a serial port at the local computer, and disable any

service that uses that port.

2. Connect the serial cable (940-0103) to the selected port

on the computer and to the configuration port at the

battery manager.

3. Run a terminal program (such as HyperTerminal

) and

configure the selected port as follows:

– 9600 bps

– 8 data bits

– no parity

–1 stop bit

– no flow control.

4. Press

ENTER, repeatedly if necessary, to display the User

Name prompt. If you are unable to display the User

Name prompt, verify the following:

– The serial port is not in use by another application.

– The terminal settings are correct as specified in step 3.

– The correct cable is being used as specified in step 2.

5. Press the Reset button. The Status LED will flash

alternately orange and green. Press the Reset button a

second time immediately while the LED is flashing to

reset the user name and password to their defaults

temporarily.

6. Press

ENTER as many times as necessary to redisplay the

User Name prompt, then use the default, apc, for the

user name and password. (If you take longer than 30

seconds to log on after the User Name prompt is

redisplayed, you must repeat step 5 and log on again.)

7. From the Control Console menu, select System, then

User Manager.

8. Select Administrator, and change the User Name and

Password settings, both of which are now defined as

apc.

9. Press

CTRL-C, log off, reconnect any serial cable you

disconnected, and restart any service you disabled.

1 2 3 4 5 6 7 8 9 10 11 ... 25 26

Comments to this Manuals

No comments

APC Network Management Card AP9618 User's Guide Page 6

Comments to this Manuals

Related products and manuals for Networking APC Network Management Card AP9618