APC Snap Server 2200 User Manual download pdf (Page 14)

Assigning an IP Address

8 Snap Server Administrator Guide

Click Power Off to begin the power off process. A confirmation page appears.

Tip To turn the server on again, you must physically engage the power switch as

described in “Turning On Your Snap Server” on page 7.

Assigning an IP Address

To configure the Snap Server and use it in some network environments, it must

have an IP address. (An IP address is a network address and is required for TCP/

IP.)

Your Snap Server can automatically obtain an IP address from a DHCP, BOOTP, or

RARP server. If your network assigns IP addresses automatically, skip to Chapter 3,

“Using Your Snap Server” on page 11.

Tip Your Snap Server must be configured to use the same subnet as the Windows

domain controller if WINS is not in use on the network.

If your network does not assign IP addresses automatically, follow the procedure

below for your computer type to assign one manually. You can also use these

procedures to look up an automatically assigned address.

Tip To change the server’s IP address once it is assigned, use the Snap Server’s Web

user interface.

Windows Computers

To assign or look up an IP address on a Windows computer:

1 Load the User CD into your computer’s CD-ROM drive.

On most computers Assist starts automatically when you load the CD-ROM. If it

does not start, view the contents of the CD-ROM drive, then double-click the

Assist program icon.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 53 54

No comments

APC Snap Server 2200 User Manual Page 14