APC AR2316BLK Datasheet download pdf (Page 37)

34 NetShelter VX Enclosure: Unpacking, Installation, Customization

How to Connect Enclosures Together

Make the front connections

The first step when connecting enclosures together

is to slide the enclosures together and align. Make

sure that the holes in the baying brackets are

aligned with the holes in the baying trim. The

connection procedure varies according to your row

configuration: 24-inch or 600-mm centers. When

you are joining enclosures configured on 24-inch

centers, align using hole . When joining

enclosures configured on 600-mm centers, align

using hole .

Make sure that the enclosures are level with each

other.

Insert a low-profile screw through the baying trim into each of the two brackets and tighten using the

3-mm hex wrench.

Make the rear connections

When joining enclosures configured on 24-inch centers, use hole . When joining enclosures

configured on 600-mm centers, use hole .

Insert a low-profile screw through the baying

plate and into the threaded hole in the frame.

Tighten using the 3-mm hex wrench.

See “How to level the enclosure” on page 8.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42

No comments

APC AR2316BLK Datasheet Page 37