APC AR2901 Datasheet download pdf (Page 17)

13NetShelter VL Enclosure—Unpacking, Installation, and Customization

Removing and Installing the Doors

Note: If the enclosures are joined together, see “Removing the Doors of Joined Enclosures”

on page 27.

Warning: To avoid personal injury or damage to the enclosure, one person should

support the door while another person removes the door from its frame.

Removing the doors

You can remove the front and rear doors of the enclosure to gain better access to equipment.

1. Disconnect the grounding wire by

removing the M6 x 12 pan-head screws

and star washers that secure the

grounding wire to the frame and door,

using the Torx T30/#2 Phillips wrench

(provided).

2. Open the door to approximately 90

degrees and lift it up and off the hinges.

Installing the doors

1. Hold the door approximately

90 degrees to the frame of

the enclosure. Align the door

hinges with the hinge pins on

the frame.

2. Lower the door onto the

hinge pins, making sure the

pins engage with the hinge

barrels on the door.

3. Reconnect the grounding

wire.

4. Make sure that the door

opens and closes properly.

ns1405a

ns0944c

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 34 35

No comments

APC AR2901 Datasheet Page 17