APC AR2901 Datasheet download pdf (Page 22)

NetShelter VL Enclosure—Unpacking, Installation, and Customization 18

Adjusting the vertical mounting flanges on the side braces

Warning: To avoid personal injury or damage to the enclosure, perform this procedure

without any equipment installed on the mounting flanges.

1. Use the Torx T30/#2 Phillips wrench (provided)

to remove the Torx screws in the slots of each

mounting flange.

2. To align the vertical mounting flanges

properly, note the symbol visible through

the hole on the top of the flange, and ensure

that the same symbol is visible through the

corresponding hole at the bottom of the

flange. Only one symbol is visible at a time

through the hole. In the factory-standard

position, the circles are visible through two

of the holes.

Note: Vertical mounting flanges adjust in 12.7-mm (1/2-in) increments.

Note: Vertical mounting flanges placed across from each other must have the same

visible symbol.

ns1470a

ns1471a

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 34 35

No comments

APC AR2901 Datasheet Page 22