APC NetShelter VX Specifications download pdf (Page 12)

NetShelter SX Enclosure: Unpacking, Installation, and Customization8

Installation

Installing the Enclosure

Warning: For extra stability, load 158 kg (350 lbs) of equipment into the bottom of the

enclosure before moving it on its casters.

Leveling the enclosure

Level the enclosure before installing equipment.

The leveling feet at the corners provide a stable base if the floor is uneven, but they cannot compensate

for a badly sloped surface. You can remove the casters and leveling feet to allow the base of the

enclosure to rest directly on the floor.

1. Move the enclosure to a level location.

2. For each leveling foot, insert a Phillips or

slotted screwdriver (not provided) into the

screw above the leveling foot. Turn the

screw clockwise to extend the leveling

foot until it makes firm contact with the

floor.

Note: If the enclosure needs to be leveled after equipment has been installed, use a 13-mm

open-ended wrench (not provided) to lower the leveling feet. For each leveling foot, fit the

13-mm end of the open-ended wrench (not provided) to the hex head just above the round pad

on the bottom of the foot. Turn the wrench clockwise to extend the leveling foot until it makes

firm contact with the floor.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

No comments

APC NetShelter VX Specifications Page 12