APC NetShelter VX Specifications download pdf (Page 8)

NetShelter SX Enclosure: Unpacking, Installation, and Customization4

Unpacking

Unpacking the enclosure

Heavy: Use at least two people to unpack the enclosure.

Warning: To prevent the enclosure from tipping over after installation:

• Stabilize the enclosure before installing the components. See “Rack stabilization

options” on page 9.

• Do not extend components on sliding rails out from the enclosure until you have

installed three or more pieces of similar equipment, or the stabilizer plate or bolt-down

brackets are installed. See “Rack stabilization options” on page 9.

• Do not extend more than one component from the enclosure at a time.

• Load the heaviest components first, and place them toward the bottom of the enclosure to

prevent the enclosure from becoming top-heavy.

• Use caution when moving an empty enclosure on its casters; the enclosure may be unstable

when pushed or pulled from the side. Push the enclosure from the front or back when

moving it on its casters. For extra stability, load 158 kg (350 lbs) of equipment into the

bottom of the enclosure before moving it on its casters.

1. Move the shipping pallet to a firm, level surface in an open area. Inspect the enclosure for visible

signs of shipping damage. If you detect shipping damage, contact APC Customer Support at the

number listed on the yellow label on the front of the enclosure or on the back cover of this

manual.

2. See the label on the packaging to determine where to cut the wrapping. Using sturdy shears or a

utility knife, carefully remove the plastic stretch wrap surrounding the enclosure.

Note: Save the bag containing the warranty card and installation manual.

3. Remove the four cardboard corner protectors.

4. Remove the two pallet-mounting brackets that anchor the enclosure to the shipping pallet, using a

13-mm wrench (not provided).

Note: Save the pallet-mounting brackets if you plan to bolt the enclosure to the floor.

See “Rack stabilization options” on page 9.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

No comments

APC NetShelter VX Specifications Page 8