APC NetBotz Rack Access Pod 170 Installation Guide download pdf (Page 11)

NetBotz Rack Access Pod 170 Installation Guide

Attaching a power supply

Depending on the NetBotz appliance and the number of cascading Rack Access

Pods, one or more power supplies may be needed to support the attached

hardware. The following chart provides a guide to the recommended number of

power supplies:

Note: Additional Sensor Pods can be added to the A-Link cascade

containing the Rack Access Pods. See your appliance installation

guide for details.

Connecting Door and Handle Sensors

Only connect sensors supported by the appliance to which the Rack Access Pod

is connected. See the installation and quick configuration manual included with

your appliance.

Caution: Only connect approved devices to ports on the Rack

Access Pod as directed in this manual. Plugging in other devices

may result in equipment damage.

Each Rack Access Pod can monitor and control two sets of door and handle

sensors. These sets are assumed to correspond to the front and back doors on a

single rack, but this is not required. Connect door and handle sensors to the

ports labeled Door #1 and Handle #1, and also Door #2 and Handle #2 on the

Rack Access Pod.

Appliance Max Rack

Access Pods

Power Supply Recommendation

Rack Monitor 570 13 One AP9505I power supply for the fourth

attached pod plus an additional power

supply for each additional four pods.

Rack Monitor 550 13 One AP9505I power supply for the third

attached pod plus an additional power

supply for each additional third pod.

Room Monitor 455 2 One AP9505I power supply.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

No comments

APC NetBotz Rack Access Pod 170 Installation Guide Page 11