Apc 3000T User Manual download pdf (Page 16)

990-7031D, Revision 5 5/01

The SmartTrim LED comes on to indicate that the UPS is compensating for a high voltage.

SmartBoost

The SmartBoost LED comes on to indicate that the UPS is compensating for a low voltage.

Low Battery

When the UPS is operating on-battery and the energy reserve of the battery runs low, the UPS beeps continuously until

the UPS shuts down from battery exhaustion or returns to on-line operation.

Cold Start

When the UPS is off and there is no utility power, use the cold start feature to apply power to the loads from the UPS’s

battery.

Note:

Cold start is not a normal condition.

Press and hold the on/test button until the UPS beeps.

Release the on/test button during the beep and the loads are powered within four seconds.

The display indicates that the voltage is between the displayed value from the list and the next higher value. For example,

with three LEDs lit, the input voltage is between 208 and 223 VAC.

If no LEDs come on and the UPS is plugged into a working AC power outlet, the line voltage is extremely low.

If all five LEDs come on, the line voltage is extremely high and should be checked by an electrician.

Note:

The UPS starts a self-test as a part of this procedure. The self-test does not affect the voltage display. The utility voltage

bar graph has a margin of error of ± 4%.

239

223

208

193

177

Utility Voltage Bar Graph

This UPS has a diagnostic feature that displays the utility voltage. With the UPS plugged into the normal utility

power, press and hold the on/test button to see the utility voltage bar graph display. After approximately four

seconds the 5-LED display on the right of the front panel shows the utility input voltage. Refer to the figure to the

left for the voltage reading (values are not listed on the UPS).

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 32 33

No comments

Apc 3000T User Manual Page 16