Apc NETBOTZ NBRK0200 User Manual download pdf (Page 13)

9NetBotz Rack Monitor 200 Installation and Quick Configuration Manual

How to Install the Temperature/Humidity Sensor

1. Choose a location and install the temperature/humidity sensor. Avoid locations in direct sunlight

or other locations that may affect the sensor reading, such as near windows, room entrances, air

ducts, or other heat sources.

Note: When securing the sensor, tighten the tie wrap over the recessed channel of the

sensor casing.

Vertical rail installation. Firmly

install the sensor mount (25 x 25-mm

[1 x 1-in] cable tie mount) at the

location you selected. Then secure the

sensor with a tie wrap.

Door-mount installation. For racks

with a perforated door, use a tie wrap to

secure the sensor.

Wall-mount installation. For a rough

wall or porous surface, install the wall

anchor at the location you selected.

Then, secure the sensor mount to the wall anchor using the screw provided. For a smooth wall

or other smooth surface, firmly install the sensor mount (25 x 25-mm [1 x 1-in] cable tie

mount). Secure the sensor to the sensor mount using a tie wrap.

2. Route the sensor cord to the Rack Monitor 200.

– If you mounted the sensor on the door, be sure the door is fully open when you route the sensor

cord.

– The 4-m (13-ft) sensor cord can be extended to a maximum of 15 m (50 ft), using RJ-45

female-to-female couplings and standard CAT-5 cables.

3. Connect the sensor to the Rack Monitor 200 (see “How to Connect Sensors to Universal Sensor

Ports” on page 10).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

No comments

Apc NETBOTZ NBRK0200 User Manual Page 13