APC S15 Operations Instructions download pdf (Page 22)

1-12

Input Power Connector

Provides for connection of one end of the supplied AC power cord

to the S10 or S15 Input Power Connector. Connect the other end to

the AC utility power source (15 Amp, 120 Vac, 50-60 Hz).

DC TRIGGER Jacks

Provides for connection of a component acting as a DC trigger,

which controls turn on/off, as well as sequencing of the

‘DELAYED1 and 2’ outlet banks. The S10 and S15 also allows

that DC signal to pass through to another connected component.

ETHERNET Surge Protected Jacks

The S15 protects a device connected to a home network from

surges traveling over Ethernet network data lines. Connect the

supplied RJ45 Cable from the wall jack (source) to the connector

marked “IN”. Connect another network cable from the connector

marked “OUT” to the network equipment to be protected.

Surge Protected Telephone Jacks (TEL/DVR/SAT/DSL)

The S15 has a telephone line splitter (2-line 4-wire with splitter)

with surge protection for components connected via telephone line.

Connect the supplied RJ11 Telephone cable from the wall jack

(source) to the telephone line connector marked “IN”. Connect

other telephone cables to the connectors marked “OUT A” and/or

“OUT B” to the equipment to be protected (Telephone, DVR,

DSS, or DSL). The S10 is 1-line 2-wire (no splitter) connector.

DATA PORT Jack (USB)

Enables the S10 and S15 to communicate with the included

PowerChute Personal Edition software. If the unit is also

protecting a home computer, the software will automatically save

files and gracefully shutdown the operating system if the S10 or

S15 are about to shutdown due to a low battery condition.

Cooling Fan

Both units provide a micro-processor controlled, ultra-quiet

cooling fan, which keeps the unit cool when operating on battery

power.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 59 60

No comments

APC S15 Operations Instructions Page 22