APC S15 Operations Instructions download pdf (Page 26)

2-2

Removing the Battery Pack

1. Remove the battery retaining bar.

2. Pull the battery straight back.

3. Push in the retaining tabs to allow the battery to come out completely.

Placing the Unit

Proper placement of the S10 or S15 should be accomplished in accordance with the

following:

Caution: The S10 and S15 weigh approximately 60 pounds each. Two-person lift is

recommended. Lift each unit carefully by firmly grasping both sides of unit in the

middle. Failure to comply may result in personal injury and/or equipment damage.

Place unit on a solid, flat surface that is capable of supporting at least 60 lbs.

Note: Avoid placing other components directly on top of or behind the unit.

Leave at least one inch of space on all sides to allow for proper air

ventilation. Do not block the fan.

If the S Type unit is to be rack-mounted, please follow these 4 basic steps:

Note: The included rack-mounting hardware is designed for 19” wide racks

only.

1. Install the rack-mount rails. (See the installation sheet located in the box containing

the rack-mount rails.)

2. Install the rail cleats. (See the installation sheet located with the cleats in the box

marked “Accessories.”)

3. Install rack-mount ears. (OPTIONAL — See the installation sheet located with the

cleats in the box marked “Accessories.”)

Note: Rack-mount ears are required only if you desire to lock the unit to the

front of the rack to prevent movement from front to rear.

Caution: Rack-mount ears should NEVER be used alone to support the unit.

Rack-mount rails should always be used to support the unit’s weight when

rack-mounting.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 59 60

No comments

APC S15 Operations Instructions Page 26