APC SBP Installation Manual download pdf (Page 19)

Installation

Smart-UPS

VT SBP with Power Distribution 10-30kVA, 208V, Installation Manual - 990-4198A 13

UPS connections.

1. Connect the four (4) UPS inputs [L1, L2, L3, N, top-to-bottom] to the Q1 Switch in the SBP.

Use a 4mm Allen wrench and torque to 24 in-lbs [2.71 Nm].

2. Connect the four (4) UPS outputs [L1, L2, L3, N, top-to-bottom] to the Q2 Switch in the SBP.

Use a 4mm Allen wrench and torque to 24 in-lbs [2.71 Nm].

3. Connect the two (2) UPS control wires to Pins 7 and 8 in the SBP Control Terminal Block. Use

a standard (flathead) screwdriver and make the screws hand-tight.

Note

• UPS cables can enter through the top or the bottom of the SBP. However,

BOTTOM is recommended.

• Refer to the Smart-UPS VT 10-30kVA, 208V Installation Manual (p/n 990-1598)

for SBP cable connections at the UPS.

UPS Inputs to Q1

UPS Outputs to

Control Wires [7, 8]

Switch [L1, L2, L3, N]

Q2 Switch [L1, L2, L3, N]

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

No comments

APC SBP Installation Manual Page 19