APC SRT5KRMXLI-6W User Manual download pdf (Page 15)

13Smart-UPS On-Line SRT5K/6K Tower/Rack-Mount 3U/4U

Connect Equipment

Note: The UPS batteries will charge to 90% capacity in the first three hours of normal operation. Do not expect

full battery runtime capability during this initial charge period.

1. Connect equipment to the outlets on the rear panel of the UPS.

Refer to “Controllable Outlet Groups” on page 21.

2. Connect the UPS to the building utility power.

Turn the UPS On/Off

The first time the UPS is turned on the Setup Wizard screen will run. Follow the prompts to configure UPS

settings. Refer to “Configuration” on page 17.

To turn on the UPS and all connected equipment, press the Power

ON/OFF button on the display panel. Follow the

prompts to either turn the UPS on immediately or after a delay, then press OK.

NOTE: When there is no input power and the UPS is off, the cold start feature can be used to turn on the UPS and

connected equipment using battery power.

To perform a cold start press the Power ON/OFF button.

The display panel will illuminate and the Power ON/OFF button will illuminate red.

To turn on the output power press the Power ON/OFF button again. Select the prompt Turn ON with NO AC and

press OK.

To turn output power off, press the Power

ON/OFF button. Follow the prompts to either turn the UPS off

immediately or after a delay, then press OK.

NOTE: Once the AC power has been turned off the UPS will continue operating on battery power for a short

period of time. To remove power completely press the Power ON/OFF button. Follow the prompt to select Internal

Power Off, then press OK.

CAUTION

DAMAGE TO EQUIPMENT OR PERSONNEL

• Disconnect the mains input circuit breaker before installing or servicing the UPS or connected equipment.

• Disconnect internal and external batteries before installing or servicing the UPS or connected equipment.

• The UPS contains internal and external batteries that may present a shock hazard even when disconnected from the

mains.

• UPS AC hardwired and pluggable outlets may be energized by remote or automatic control at any time.

• Disconnect equipment from the UPS before servicing any equipment.

Failure to follow these instructions can result in equipment damage and minor or moderate injury.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

No comments

APC SRT5KRMXLI-6W User Manual Page 15