Network Shutdown Module V3
User guide
Network Shutdown Module V3 – User Manual Page 8/53
2 Installation
Note: This user manual only applies to Network Shutdown Module V3. For previous versions of Network
Shutdown Module V2.x, please read the HTML on line manual.
2.1 Hardware Pre-requisites (Electrical and Network Connections)
Connection steps
Before installing the Network Solution, the UPS must be set up as indicated in the steps below.
• Shut down the computers to be protected by the UPS.
• How to connect UPS / card / network:
o If a Network Management Card is used, insert the optional card in the UPS and connect the
UPS to the computer network.
• Start the UPS, then the computers.
• Setting up the protection
o If a Network Management Card is used, it must be set up (see the Mgt. Card's user manual).
• Install Network Shutdown Module on all the other machines that are to be protected by the UPS (supplied
with UPS battery backup power).
Comments to this Manuals