APC S15 Operations Instructions download pdf (Page 33)

2-9

Status and Informational Screens

The following sections describe the status and informational screens.

Status Screens

The most important status screens available after the Selftest has completed consist

of:

• INPUT VOLTAGE: XXXV; OUTPUT VOLTAGE: XXXV

• SYSTEM LOAD: <XXXW; LOAD: <XXX%

• EST. RUNTIME: XHRS; FUEL: XXX%

INPUT VOLTAGE: XXXV; OUTPUT VOLTAGE: XXXV

This screen (Figure 14) shows the actual input utility voltage level, as well as the

actual voltage level being output to the connected devices.

Note: As shown in Figure 14, at times, the voltage values on this screen may not

match. This may be due to the fact that separate circuits are used to make

these voltage measurements, and there is a time delay between the two

circuits for updating this status screen. This condition is considered part

of the normal operation of the unit. Also, the voltage values may not

match if the AVR is active.

Figure 14. INPUT VOLTAGE: XXXV; OUTPUT VOLTAGE: XXXV Screen

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 59 60

No comments

APC S15 Operations Instructions Page 33