APC UTS6BI User Manual download pdf (Page 16)

15 Site Preparation & Installation Guide Universal Transfer Switch UTS6 UTS6H UTS6BI UTS10BI

UTS Controls and Indicators

The UTS controls and indicators are located on the front of the UTS.

Control or Indicator Description

! LCD • Displays two lines with 20 characters per line

• Displays UTS status, warnings, general information

• Displays the value or setting that is being entered or changed during

configuration and setup

" System Status button Cycles the UTS through the default or selected system status options

# System Setup button Used to configure the UTS system options

$ Circuit Status button Cycles the UTS through the circuits displaying the status of each on the LCD

% Circuit Setup button Used to configure the UTS individual circuit options

& Down/Up arrow buttons Used to scroll through steps for configuration and to scroll between status and

informational displays

' Source LEDs

Utility

Generator

UPS

• Solid green LED illumination indicates that the power source is ON and is

functioning normally

• No LED illumination indicates that the power source is OFF or is outside

specified limits

• A flashing green LED indicates that a fault condition exists for that power

source, and should be corrected

( Circuit LEDs The number of circuit LEDs varies dependent on the model of UTS

• Red LED illumination indicates that the UTS circuit is receiving power from

one of the power sources

• No illumination indicates that circuit is receiving no power

• A flashing red LED indicates that a fault condition exists and should be

corrected

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 29 30

No comments

APC UTS6BI User Manual Page 16