APC AP9224 Datasheet download pdf (Page 21)

18 MasterSwitch VM: Installation and Quick Start Manual

Connecting MasterSwitch VM

Setting up

multiple units

To set up multiple units in a cascading configuration:

1. Plug each MasterSwitch VM unit into a protected power

source.

2. Connect the 10Base-T network port located on the rear

panel of the controller to the network, using an

appropriate cable.

3. Connect the MasterSwitch VM units.

a. Insert one end of a communication cable (APC part

number 607-0035A) into the RJ-11 port labeled “Out”

on the last unit (unit  in the following figure).

b. Insert the other end of the communication cable into

the RJ-11 port labeled “In” on the next unit (unit  in

the following figure).

c. Connect unit  to unit  and unit  to unit  in the

same manner.

Out



Out







1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

No comments

APC AP9224 Datasheet Page 21