APC AP9224 Datasheet download pdf (Page 26)

MasterSwitch VM: Installation and Quick Start Manual 23

9. Within the TCP/IP menu:

a. Disable BOOTP

b. Accept changes.

c. Set a valid IP address, Subnet Mask and default

Gateway for your network.

d. Accept changes.

e. Press

ESC until the Main menu appears.

f. From the Main menu, select Logout.

Over the Network by BOOTP. BOOTP is enabled by default.

Use a BOOTP server to configure MasterSwitch VM

TCP/IP

settings and perform the following steps:

1. Enter the MasterSwitch VM

MAC address, IP address,

Subnet Mask, default Gateway, and optional boot-up

filename.

2. The

BOOTP server will provide network settings to

MasterSwitch VM. If a boot-up file name was specified,

MasterSwitch VM will attempt to transfer that file from a

TFTP or FTP server residing on the same computer as the

BOOTP server. MasterSwitch VM will assume all

settings specified in the boot-up file. Otherwise,

MasterSwitch VM can be configured remotely using the

Telnet, Web, or

SNMP interfaces.

Note

The new settings will not take effect until

you log out.

Note

Look for the MAC address on the Quality

Assurance slip or on the

TCP/IP menu

from the Control Console.

ote

You must use the Management Card Wizard to

create the boot-up file.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

No comments

APC AP9224 Datasheet Page 26