APC NETBOTZ NBRK0200 Specifications download pdf (Page 13)

9NetBotz Rack Monitor 200 Installation and Quick Configuration Manual

Power cord and network cable connections

Perform the steps below to complete the installation of the NetBotz 200.

Caution: Before you energize the NetBotz 200, review the electrical specifications on

page 23 to avoid overloading the circuit providing power.

Caution: Make sure you properly ground the NetBotz 200 by plugging it directly into a wall

outlet or by verifying the ground path if you connect the appliance to a power strip.

1. Connect the appropriate power cord to the AC Line Inlet of the NetBotz 200.

2. Secure the power cord to the power cord retainer bracket using the tie wraps.

3. Connect your 10/100 Base-T Network cable to the NetBotz 200.

4. Plug the power cord into a power source.

5. Use the hook and loop cable strap to secure cables.

Connect Sensors to Sensor Ports

This procedure applies to the following sensors, which are supported by the NetBotz 200 and connect to

the sensor ports:

• Temperature Sensor (AP9335T)

• Temperature/Humidity Sensor (AP9335TH)

• NetBotz Door Switch Sensor for APC Racks (NBES0303)

• NetBotz Door Switch Sensor for Rooms or Third Party Racks (NBES0302)

• NetBotz Dry Contact Cable (NBES0304)

For sensors that connect to A-Link ports (Temperature Sensors with Digital Display

[AP9520T] and Temperature/Humidity Sensors with Digital Display [AP9520TH]), see

“Connect Sensors and Sensor Pods to A-Link Ports” on page 11.

Connect APC and third-party dry contact sensors to the six universal sensor ports, labeled Sensors, on

the NetBotz 200.

• Third-party dry contact sensors require the NetBotz Dry Contact Cable (NBES0304). To connect

a sensor to the cable, follow the instructions provided with the sensor and the instructions

provided with the cable.

• If a sensor cable is not long enough, use an RJ-45 coupling (provided with some sensors) and

standard CAT-5 cabling to extend the cable up to 15 m (50 ft) for a Temperature/Humidity Sensor

(AP9335TH) or a Temperature Sensor (AP9335T) and up to 30.5 m (100 ft) for all other

supported sensors.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

No comments

APC NETBOTZ NBRK0200 Specifications Page 13