APC NETBOTZ NBRK0200 Specifications download pdf (Page 25)

21NetBotz Rack Monitor 200 Installation and Quick Configuration Manual

Simple Network Management Protocol (SNMP)

SNMPv1 only. After you add the PowerNet

MIB to a standard SNMP MIB browser, you can use that

browser to access the NetBotz 200. All user names, passwords, and community names for SNMP are

transferred over the network as plain text. The default read community name is public; the default read/

write community name is private.

SNMPv3 only. For SNMP GETs, SETs, and trap receivers, SNMPv3 uses a system of user profiles to

identify users. An SNMPv3 user must have a user profile assigned in the MIB software program to

perform GETs and SETs, browse the MIB, and receive traps. The default settings are no authentication

and no privacy.

Note: To use SNMPv3, you must have a MIB program that supports SNMPv3. The NetBotz

200 supports only MD5 authentication and DES encryption.

SNMPv1 and SNMPv3. To use InfraStruXure Central or InfraStruXure Manager to manage the

NetBotz 200 on the public network of an InfraStruXure system, you must have SNMPv1 enabled in the

unit interface. Read access allows InfraStruXure devices to receive traps from the NetBotz 200. Write

access is required while you set the InfraStruXure device as a trap receiver.

To enable or disable SNMP access, you must be an Administrator. Select the Administration tab, select

the Network menu on the top menu bar, and use the access option under SNMPv1 or SNMPv3 on the

left navigation menu.

Modbus

Modbus lets you view the NetBotz 200 through the interface of your building management system. It is

read-only.

The Modbus interface supports 2-wire RS-485, plus ground.

Note: Modbus can be configured to run at either 9600 or 19200 bps.

See “Additional Documentation” on page 1 for details on accessing the Modbus register map.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

No comments

APC NETBOTZ NBRK0200 Specifications Page 25