Backing Up Server and Volume Settings
Chapter 6 Data Protection 117
This operation may take a few minutes. As the operation progresses, the screen
reports the progress of the operation. When the operation is finished, scroll to the
bottom of the screen, and click
Continue
. The Continuing Fresh Install Operation
screen opens.
3
When the Fresh Install operation is finished, click
Reboot
.
Rebooting takes about three minutes, after which you can refresh the screen by
clicking the
Home
icon in the upper right corner of the screen. The Enter Network
Password dialog box opens.
4
Log into the Snap Server.
Use the default admin
,
admin
user name and password.
5
Complete the Setup Wizard as described on page 30.
Make sure to enter the original server name, then reboot the server.
Manually Creating the Original RAID Sets and Volumes
Before you can restore data from tape, you must manually create the same number
of volumes as in the original configuration, and each volume must have the same or
more space as the originals. The processes summarized below are described in
detail starting on page 60.
1
Navigate to the
Storage > RAID Sets
screen and click
Create RAID Set
. Using the
screens that follow, recreate the original RAID configuration.
2
Navigate to the
Storage > Volumes
screen and click
Create Volume
. Using the
screens that follow, recreate the original Volume configuration.
3
Navigate to the
Storage > Shares
screen and click
Create Share
. Using the screens
that follow, recreate the original share configuration.
Comments to this Manuals