APC Snap Server 2200 Specifications download pdf (Page 30)

Configuring TCP/IP Settings

16 Snap Server Administrator Guide

Make Sure the Switch is Set to Autonegotiate Speed/Duplex Settings

When the server is shipped from the factory, both ports are set to autonegotiate.

This setting allows the Snap Server to base speed and duplex settings on the

physical port connection to a switch. Thus, the switch/hub to which the Snap

Server is cabled must be set to autonegotiate to initially connect to the server;

otherwise, network throughput or connectivity to the server may be seriously

impacted.

Changing from Auto to a Fixed Setting

You can configure a fixed setting on the

Network > TCP/IP

screen in the browser-

based Administration Tool. If you change this setting, be sure to: 1) configure the

fixed setting in the Administration Tool first; and second, (2) configure the switch to

the same fixed setting. If you change the switch setting before you change the

setting in the Administration Tool, the Snap Server may not connect to the network.

The Link light on the front panel of the Snap Server will be off or amber if the server

is not connected to the network.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 147 148

No comments

APC Snap Server 2200 Specifications Page 30