APC AR2105BLK Datasheet download pdf (Page 20)

Installation: Vertical Mounting Rails

16 NetShelter VX 25U Enclosure

How to reposition the vertical rails using the horizontal braces

You can reposition the two front, the two rear, or all four vertical rails along the horizontal braces to

accommodate your equipment. You can reposition the vertical rails even if they are configured for

19-inch equipment. The procedure is the same for all of the vertical rails.

1. Remove the side panels.

2. Use the 5-mm hex wrench (provided) to remove the hex-head screws from the slots of the

vertical rails.

3. Locate the new position for the vertical rails.

4. Insert a caged nut into each appropriate hole at the new position on the upper and lower

horizontal braces.

5. Place the mounting rail at the

new position. Insert a hex-head

screw through the rail into the

caged nut, in the upper and

lower horizontal brace. Tighten

the screws to secure the vertical

mounting rail to the horizontal

braces.

6. Repeat steps 2 thru 5 for the

opposite side of the enclosure.

Warn

When the vertical rails are attached to the side braces, no more than 1000 lb

(453.6 kg) of equipment should be mounted in the enclosure.

See “How to Remove and Install the Side Panels” on page 9.

Note

If necessary, adjust the position of the horizontal braces up or down to align with

the vertical rails.

See “How to move a brace” on page 17.

See “How to install and remove caged nuts” on page 18.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

No comments

APC AR2105BLK Datasheet Page 20