APC Back UPS 1400 VA User Manual download pdf (Page 12)

7. Expand the rail so that it spans from the front rack post

to the back rack post.

8. Use three screws and washers to attach the rail to the

back rack post. Use the same hardware (10-32 flat

head screws and conical washers) used in step 5.

9. Repeat steps 5 through 8 for the other rail.

Attach the Mounting Hardware to the UPS

• Each mounting bracket attaches to the UPS with four (4) screws, included.

• Two sets of bracket holes are located on the sides of the UPS. Attach the mounting brackets in

the forward position for a four-post rack or the mid-point position for a two-post rack.

Bracket Position for a Four-Post Rack Bracket Position for a Two-Post Rack

If you are using a two-post rack, reposition the mounting brackets to the mid-point

position before mounting the UPS in your rack.

Check the rack to make sure it will not tip after moving the UPS mounting

brackets.

• For Four-Post Racks: Attach a mounting cleat to each side of the UPS.

Right Rear Rack Post

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 30 31

No comments

APC Back UPS 1400 VA User Manual Page 12