APC BP1400 User Manual download pdf (Page 19)

English

10.3 Battery Replacement Procedure (280, 420 and 650 VA

models)

Note:Note:

Note: Please read the cautions in section 10.1.

Battery replacement is a safe procedure, isolated from electrical hazards. You may leave the UPS and loads

on for the following procedure.

1. Lay the UPS on its left side. Remove the two screws holding on the battery door and

openopen

open the door.

Note:Note:

Note: The battery door may need to be pulled away from the hinges somewhat to allow it to become

fully swung open.

2. Gently

pullpull

pull out the battery by grasping the white tab.

DisconnectDisconnect

Disconnect the two wires connecting the battery to the UPS. Loosen the wires by gently wiggling them

while pulling straight back from the battery connector.

ConnectConnect

Connect the new battery in place of the old.

Note:Note:

Note: Small sparks at the battery connections are normal

during connection.

placeplace

place the new battery in the UPS. Use care to avoid pinching the wires.

CloseClose

Close the battery compartment door and replace the screws.

DisposeDispose

Dispose of the old battery properly at an appropriate recycling facility or return it to the supplier in the

packing material for the new battery. See the new battery instructions for more information.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 65 66

No comments

APC BP1400 User Manual Page 19