APC H15 Service Manual download pdf (Page 41)

User’s and Service Guide 5-7

Controlling the Test Set and Making Measurements

Commands

To connect all ports to their internal 50 Ω loads, send the following

command:

NOTE When a test set port is not in use, it is terminated in 50 Ω.

If the Agilent 87050A Option H15 is being controlled by GPIB (HP-IB),

you can read the serial number of the test set by sending the following

commands:

When the RESET command is sent, the test set is set to a known state

where the Reflection port is directed to Port 1 and the Transmission

port is directed to Port 2.

Refer to the Option H15 block diagram, Figure 6-1 on page 6-22, for the

switch paths.

The switch count represents the number of times each switch has been

activated. To read the individual switch count, send the following

command:

The above example shows the SW11 command only. To enter additional

commands use Table 5-2 on page 5-8.

OUTPUT 712;"*all_term;"

OUTPUT 712;"sn?"

ENTER 712:Sn$

DISP Sn$

OUTPUT 712;"SW11?"

ENTER 712; COUNT$

DISP COUNT$

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 85 86

No comments

APC H15 Service Manual Page 41