APC AP9341 Specifications download pdf (Page 10)

6 Temperature/Humidity Module

Installation—Accessories

Sensors

Selecting a location for the sensor:

Install the sensor in a location that represents the

air to be monitored. Avoid placing the sensor

anywhere that may affect the sensor reading, such

as near windows, room entrances, air ducts, other

heat sources, or in direct sunlight.

To install a sensor on the vertical rail of an

APC rack:

1. Determine a location on the vertical rail that

will allow you to route and secure the 13-ft

(4-m) cord neatly.

2. Peel the backing off the adhesive side of a

sensor mount, and press the cable mount

firmly to the vertical rail.

3. Thread a wire tie through the sensor mount.

4. Secure the sensor to the sensor mount with the

tie. Tighten and trim the wire tie.

5. Thread the sensor cord through the opening in

the front post of the rack.

6. Route the cords between the vertical support

rail and the side panel. Each sensor cord may

be extended to a maximum of 50 ft (15 m),

using RJ-45 couplings and standard CAT5

cables.

To install a sensor on the door of an APC

rack:

1. For optimal sensor performance, install the

sensor near the top of the rack door. The

bottom of the rack door will not accurately

represent the temperature of the air in the

room.

aem0184a

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Comments to this Manuals

No comments