APC NBPD0160 Specifications download pdf (Page 27)

23NetBotz Rack Monitor 450/550 Installation and Quick Configuration Manual

Connect external sensors

To install an external sensor, plug the sensor into an available External Port on any Sensor Pod 150,

Sensor Pod 155, or Sensor Pod 120.

Note: When connecting a sensor to a Sensor Pod 120, be sure to note both the sensor pod serial

number, located on the back of the pod, and the number of the External Port on the pod when

you connect the cable. You will need this information when you use the sensor pod task to

configure your appliance. The External Port number is printed above the port on the pod.

The female connectors on the NetBotz 120 Sensor Pod units are Version 2, NetBotz DIN

standard connectors and can only accept male, Version 2, NetBotz DIN Sensor Cables. The

new Version 3 products use standard RJ-45 connectors.

If the external sensor cable is not long enough, use an Extension Cable for External Sensors,

available in 15 m (50 ft) and 30 m (100 ft) lengths from your NetBotz reseller, to lengthen the

cable.

When you have finished installing external sensors, use the Sensor Pods task to configure the appliance

to use the external sensor. Once you configure your appliance, an additional temperature sensor appears

in the Sensor Data pane when the pod to which it is connected is selected from the Navigation pane. Use

the Advanced View Sensor Pods task to specify thresholds for this external sensor.

Disposal

Warning: NetBotz Rack Monitor appliances contain non-replaceable, lithium coin-cell

batteries. Do not attempt to replace the battery. Please take the battery into consideration

when disposing of the appliance.

Clean the NetBotz 450/550

To clean the device, gently wipe surfaces with a clean, dry cloth.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

No comments

APC NBPD0160 Specifications Page 27