APC Silcon Installation Guide download pdf (Page 4)

4 Installation Guide Silcon DP300E 480V 120-160kVA

7OH0006 US rev. 03

Introduction

WARNING!

The UPS and related equip-

ment are very heavy. To prevent

personal injury or equipment

damage, please use extreme

care when handling and

transporting the UPS cabinet

and related equipment.

WARNING!

Never lift or transport the

system without front doors and

without the internal front cover

plate mounted and fastened

with screws.

1.0 Introduction

The information provided in this installation guide is of a general nature for a local

authorized electrical installer. Please refer to local/national electrical codes for more

information.

SPE Factory Warranty:

1 year on parts and on-site labor. Labor response time is best endeavour. Travel

expenses are not included. An APC Start-Up Service must be performed/completed

by an APC or APC authorized service personnel or this on-site factory warranty (on-

site labor) will be void. Parts will only be covered upon right commissioning and

installation.

1.1 Required tools and equipment

This section lists all tools that could be required to install the UPS and related

equipment. Whether all tools are used, depends on what UPS configuration you are

using.

Tools needed for installation of Silcon DP3120E and Silcon DP3160E:

10 mm socket

13 mm socket–deep

17 mm socket

3/4” or 19 mm socket–deep

3/4” or 19 mm combo wrench

Small flat/regular screwdriver

#3 philips screwdriver

Compression lug crimp tool

Knock–out set (for conduit)

Supplies needed:

Compression lugs for power terminations

Cable to service bypass panel from system feeder (see wire sizing)

Cable to UPS input from service bypass panel (see wire sizing)

Cable to service bypass panel from UPS output (see wire sizing)

Cable from service bypass panel to customer distribution (see wire sizing)

Cable to UPS from external batteries/external MCCB (see wire sizing)

Control wire, solid core, to UPS from service bypass panel (see control wiring)

Control wire, solid core, to UPS from external batteries/external MCCB (see

control wire)

Conduit necessary for above listed cabling (see wire size for requirements)

1 2 3 4 5 6 7 8 9 ... 71 72

Comments to this Manuals

No comments

APC Silcon Installation Guide Page 4

Comments to this Manuals

Related products and manuals for Power supply units APC Silcon