APC EP Zero ARF User Manual download pdf (Page 10)

❏ 4. Epoxy a servo into the bottom of the rear servo cutout

from the left side of the plane. The output shaft should be

toward the front of the fuselage. Center the servo with your

radio and screw the extended arm onto the output shaft with

the arm oriented straight up.

❏ 5. Epoxy the other tail servo into the cutout from the right

side of the plane side with the output shaft toward the front.

Center the servo with your radio and screw the extended arm

onto the output shaft with the arm oriented straight down.

❏ 6. Center your aileron servo with your radio and screw the

extended double-sided arm onto the servo.When you glue the

extended servo arm, be sure it is exactly centered as shown.

Epoxy the aileron servo into the cutout in the fuselage.

❏❏1. Locate the two 2-3/4" [70 mm] prebent aileron

pushrods. Slightly enlarge the outer hole on the aileron

servo arm. Insert the Z-bend end of the pushrods into the

outer hole on the aileron servo arm.

❏❏2.Center your aileron servo to ensure it is at neutral.Use

a small clamp or some masking tape to hold the aileron at

neutral. Align the pushrods straight back towards the ailerons.

❏❏3. Locate a black nylon control horn. Trim the small

plastic section away as shown.

❏❏4. Make a small 1/4" [6.4 mm] long cut in the aileron

behind the bearing. Insert the 90° bend of the pushrod into

the middle hole of one of the black nylon control horns.

Install the Control Horns & Pushrods

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

No comments

APC EP Zero ARF User Manual Page 10