APC EP Zero ARF User Manual download pdf (Page 11)

❏❏5. Apply a small spot of foam-safe CA to the bottom of

the control horn and insert it into the cut in the aileron. Press a

nylon backplate on the backside of the control horn as shown.

❏❏6. Install a black nylon snap keeper onto the pushrod

at the control horn.

❏ 7. Install the rudder and elevator pushrods in the same

way as the ailerons. Use the 5-3/4" [146 mm] prebent

pushrod for the rudder and the 2-1/2" [64 mm] prebent

pushrod for the elevator.

❏ 1. Connect the output wires of your ESC to the motor.

Check the direction of the motor before permanently

installing it.

❏ 2.Install the ESC as shown using a small section of hook

and loop tape. Place the hard “hook” side in the provided

cutout in the fuselage and the softer “loop” side on the back

of the ESC. If your ESC has a BEC switch, install it in the

provided cutout. For some electronic speed controls, it may

be necessary to trim the foam slightly to allow for wire

clearance and switch mounting.

❏ 3. Slide the gearbox onto the square wood stick in the

nose. Secure it with the supplied #2 x 3/8" [9.5 mm] screw.

Install the Motor & Speed Control

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

No comments

APC EP Zero ARF User Manual Page 11