Apc NETBOTZ NBRK0200 User Manual download pdf (Page 25)

21NetBotz Rack Monitor 200 Installation and Quick Configuration Manual

Telnet for basic access. Telnet provides the basic security of authentication by user name and

password, but not the high-security benefits of encryption. To use Telnet to access the control console of

the Rack Monitor 200:

1. At a command prompt, use the following command line, and press

ENTER:

telnet address

As addr ess, use the IP address of the Rack Monitor 200 (or DNS name if configured).

2. Enter the user name and password (by default, apc and apc for an Administrator, or device and

apc for a Device User).

SSH for high-security access. If you use the high security of SSL for the Web interface, use Secure

SHell (SSH) for access to the control console. SSH encrypts user names, passwords, and transmitted

data.

The interface, user accounts, and user access rights are the same whether you access the control console

through SSH or Telnet, but to use SSH, you must first configure SSH and have an SSH client program

installed on your computer.

See the NetBotz Rack Monitor 200 User’s Guide for more information on configuring and

using SSH. For details on how to access the user’s guide, see “Additional Documentation” on

page 1.

Simple Network Management Protocol (SNMP)

SNMPv1 only. After you add the PowerNet

MIB to a standard SNMP MIB browser, you can use that

browser to access the Rack Monitor 200. All user names, passwords, and community names for SNMP

are transferred over the network as plain text. The default read community name is public; the default

read/write community name is private.

SNMPv3 only. For SNMP GETs, SETs, and trap receivers, SNMPv3 uses a system of user profiles to

identify users. An SNMPv3 user must have a user profile assigned in the MIB software program to

perform GETs and SETs, browse the MIB, and receive traps. The default settings are no authentication

and no privacy.

Note: To use SNMPv3, you must have a MIB program that supports SNMPv3. The Rack

Monitor 200 supports only MD5 authentication and DES encryption.

SNMPv1 and SNMPv3. To use InfraStruXure Central or InfraStruXure Manager to manage the Rack

Monitor 200 on the public network of an InfraStruXure system, you must have SNMPv1 enabled in the

unit interface. Read access allows InfraStruXure devices to receive traps from the Rack Monitor 200.

Write access is required while you set the InfraStruXure device as a trap receiver.

To enable or disable SNMP access, you must be an Administrator. Select the Administration tab, select

the Network menu on the top menu bar, and use the access option under SNMPv1 or SNMPv3 on the

left navigation menu.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

No comments

Apc NETBOTZ NBRK0200 User Manual Page 25